50pcs/CTN , 14.5KGS, 1.9' CUFT

https://www.youtube.com/watch?v=7abSm4YBW8Y

High Pressure Air Shock Pump 300 psi

This air shock pump is used to adjust air suspension pressure in front or rear suspensions. It can be used on Harley touring Dresser bagger (which use a pneumatic rear suspension system requires to be adjusted during each rider and luggage weight changes), or any motorcycle with air shocks, it also can be used on bicycles.

For Harley Davidson bikes, we recommend to use 0-60 PSI air shock pump, ASIN: B006ID37ZS , (just put in Amazon search bar, it will come up in the result.) as the manufacturer recommended setting is below 60 PSI.

Specification

Gauge is made of die case, face dia: 1.5"

Reads 0-300 psi

10 PSI Increments

Handle is made of aluminum 6063, overall length is about 9", takes very little room in your storage bag.

360 degree 180mm long swivel-style hose for easy access

No air escaping coupling

In the swivel head of the hose, there is a small built-in O-ring will seal in the valve stem.

When pump in the air, it presses down and opens the valve stem.

This neat feature will prevent any air from escaping during attaching or removing the pump from the valve stem

(if it doesn't register air when pumping, very likely, you need to replace the valve stem)

Built-in bleeder button

With the built-in air control bleeder button

the user can bleed the excess air from the suspension system until the desired pressure is achieved.

Simple use

1. Remove valve stem cap, thread the swivel head of the pump hose onto the valve stem
2. Pump the air shock pump, usually pump it up a little higher then the specific PSI you want.
3. Use the bleeder button to release excess air in order to reach the desired PSI.
4. Remove the pump, the O-ring in the swivel head will prevent any air from escaping out of the fork.